CATV RF Fiber Receiver - High RF power - Rack Mountable
Optical CATV RF Receiver - High RF Output Power - Rack Mountable
F-RF-RX-RM. The F-RF-RX is used for receiving RF cable TV signals (45-870MHz) that are transmitted over an optical fiber. The unit can receive optical signals in either the 1310nm or the 1550nm bands. Designed to work well with the F-RF-TX units, the F-RF-RX is built with one optical receiver as well as one power supply. A second redundant power supply can be included; please contact a Thor Fiber sales rep for pricing. The F-RF-RX features an easy-to-read front panel LCD screen that displays relative operating status and fault information. All operating parameters of the F-RF-RX series receivers are designed for high reliability and are suitable for even the most high-end applications.
Related keywords:
RF fiber optic receiver, broadband optical receiver | Cable TV optical receiver | Cable TV fiber optic receiver | RF over fiber | fiber to RF | RF to fiber | coax to fiber | fiber to coax |
Radio over fiber | RF fiber optic transport | RF fiber optic transmission | Antenna over fiber |
- Optical Automatic Gate Control (AGC)
- Able to receive optical signals in either the 1310nm or 1550nm bands.
- All working parameters controlled by a microprocessor and displayed on screen
- Optical receiver with SC/APC
- Easy-to-read RF parameters displayed on LCD screen
IMPORTANT NOTE*** (It is very important to interface our unit with an SC/APC - Angle Polished Connector to avoid any light reflections.)
If your fiber is terminated with the SC, ST, FC/PC flat connector, you need to use an optical jumper from PC type to SC/APC for proper conversion.
| *All Specifications Subject to Change Without Notice | |||
| Optical Features | |||
|
1310 - 1568 nm | ||
|
< 1 MHz FWHM | ||
|
> 45 dB SMSR | ||
|
> 55 dB | ||
|
SC/APC Standard IMPORTANT NOTE*** (It is very important to interface our unit with SC/APC - Angle Polished Connector to avoid any light reflections.) If your fiber is terminated with the SC, ST, FC /PC flat connector, you need to use an optical jumper from PC type to SC/APC for proper conversion. |
||
| RF Features | |||
|
45 - 862 MHz | ||
|
19 - 21 dBmV MGC | ||
|
<+/- 0.75 45 - 862 MHz | ||
|
> 16 dB | ||
|
75 Ohm RF Input | ||
|
F-Type or by request | ||
| Link Features | |||
|
PAL-D/60CH NTSC/80CH | ||
|
> 50 dB on 10Km optical fiber | ||
|
< -63 dB | ||
|
< -57 dB | ||
|
> 17 dBm | ||
| General Features | |||
|
RJ45 & RS232 Supports I.E. & SNMP | ||
|
90~265VAC -48VDC optional(30~60VDC) | ||
|
< 50 W | ||
|
-5 - 65 deg C | ||
|
-40 - 85 deg C | ||
|
5 - 95 % | ||
|
19x10x1.75 (W)x(D)x(H) | ||